Wire Wheel® Model 415D wire dispenser has 2 wheels that hold 250' rolls of NM Cable. This is the ORIGINAL- MADE IN THE USA!

For over 30 years we’ve been producing top quality products for electricians. The Wire Wheel is a tough, impact resistant, high density polyethylene wheel(s) mounted on a zinc plated steel frame. Our product is built durably to withstand hard working conditions, providing long-lasting service.

• Our product is PROUDLY MADE IN THE USA
• The Wire Wheel is free standing, no stud or joist required. This means you can use it in many places where the competition can’t go, such as A/C hookups, outdoor jobs, remodels and service work.
• The Wire Wheel feeds cable both vertically and horizontally with ease.
• The Wire Wheel is easy to load. Tip it on its side, rotate the latch and remove the lid. Lay the coil of wire in and replace the lid, secure the latch, and stand upright. You’re done in 10 seconds.
• The enclosed design prevents overspin, dropped loops, and knots that are common with other wire dispensers. This is an incredible asset when working in attics or crawl spaces.
• The Wire Wheel eliminates trips to the truck and gives your vehicle and jobsite a clean, professional look.
• The easy carry design means minimal cable laying around on the floor where it can be damaged or wasted. Excess cable can be wound up in just a couple seconds.
• The 415D Wire Wheel holds a variety of wire sizes, including 250 foot rolls of 14/2, 14/3, 14/4, 12/2, 12/3 and 10/2.
• The inside dimmensions of the 415D wheel is 4 inches wide and up to 15 inches in the outside diameter.